iPad Hold Downs

Small little plastic hold down piece to allow attaching of iPad onto wooden surface with 3mm screw hole.

I have 3 3D models for 3 different thickness of iPads: 5.9mm, 6.1mm and 7.5mm

For each thickness, the total gap adds 1mm of clearance.

Non-exhaustive list of iPads model for each thickness:

5.9mm:

iPad Pro 12.9-in. (3rd generation)
iPad Pro 11-in. (1st generation)
iPad Pro 12.9-in. (4th generation)
iPad Pro 11-in. (2nd generation)
iPad Pro 11-in. (3rd generation)
iPad Pro 11-in (4th generation)

6.1mm:

iPad mini 4
iPad Mini (5th generation)
iPad Air 2
iPad Air (3rd generation)
iPad Air (4th generation)
iPad Air (5th generation)
iPad Pro 9.7-in.
iPad Pro 10.5-in.

7.5mm:

iPad (5th generation)
iPad (6th generation)
iPad (7th generation)
iPad (8th generation)
iPad (9th generation)
iPad Mini 2
iPad Mini 3
iPad Air (1st generation)

Note 1: If your iPad has a protruding camera at the back, this model may not work.
When I attached an iPad Pro 12.9-in. (3rd generation) onto a wooden board, I first drilled out a hole for the camera so that the iPad sits flush on the wooden board.

Note 2: I have added new files that incorporate 2 screw holes instead of 1. This makes screwing the hold down onto a surface easier.