Summary

Glassware stoppers come in numberical sizes. This upload offers molds for 0 to 10 sizes. T

Print Settings

Printer Brand:

Creality

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>CR-10</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>25%</p></div></p>                                                    <strong>Filament:</strong> unknown PLA                gray                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>There is a small hole in the bottom of each mold that should be taped over before adding the silicone polymerization mix.   I use a thin layer of petroleum jelly as a release agent.  The small hole allows you to push against the stopper to help it out of the mold.  If you don't like the small lump on the bottom of the stopper a razor blade will remove it easily.  It makes no difference for its use as a stopper.  </p></div>

0-10 size test tube/flask silicone stoppers molds