Swivel hinge and base for LCD holder

UPDATE, Added two additional variations to the printer mounted part that shift the display a little further to the left. This is to accommodate my wide spool holder which was fouling the display.

Still working on this, needs a few tweaks to get it just right but the idea is there. Uses the LCD holder from Gadgets3D LCD mount for Prusa i3

Modifies it by adding a single piece hinge assembly and a keyway into the base part which allows the display to tilt up and down and rotate for easier viewing at different angles.
Known issues: Pin is slightly too small, nut recesses on base too small, base holes are too small. If there is enough interest I will update the design and post new files.
Update 18/1/05 This version should assemble better.