Makerfarm Rear Mounted Spool Holder

This is a spool holder that replaces the left and right side of a Makerfarm i3V 8" LCD mount to allow a spool of filament to be held behind the printer. This design was created to reduce the over amount of space the printer takes up and to place the spool closer to the printer's center of gravity.

Right now, the spoke it the right length for the thinner (57mm wide) spool from Makerfarm.

Hardware needed:
(4x) M3x16 Bolt
(4x) M3 Nut

UPDATE 1/8/17
I uploaded a long spool spoke/holder part to accommodate thicker spools up to 100mm wide.This part is called "spoke v4 long (repaired).stl" and is a drop in replacement for the previous spoke parts.

UPDATE 4/13/15
If you're having trouble getting the right side to slice, please check out a repaired version that Mike_Dawson created below! Thanks Mike_Dawson!
http://www.thingiverse.com/thing:768608

If you have any questions please feel free to leave a comment!

Thanks!