Summary

This is a remix from https://www.thingiverse.com/thing:4235187

I modified it to fit onto a tripod using two 13 mm clips.

The height is ~4.5 inches.
The length is ~3.5 inches
The width is ~1.5 inches.

My portable charger is a little over 1 inch wide and it slides right in snug. The clips are also snug on the tripod so it stays suspended.

Print Settings

Printer Brand:

FlashForge

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Finder</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>30%</p></div></p>                                                    <strong>Filament:</strong> Any PLA                Any

Portable Charger Holder for Tripod