Summary

Needlessly decorative knife holder; holds most of my kitchen knives.

Instructions

Recently acquired a bunch of 1/4 inch dowels, and needed a knife holder, so...
.
The horizontal dowels are 82.5mm long, the front dowels are 214mm long, and the back dowels (left to right) are 211mm, 210mm, 208mm, 211mm, and 210mm long. Project used ten twelve-inch dowels. No supports needed for print (.4mm nozzle, .2mm layer, 2 perimeters, 25% infill).
.
Some dowel pockets are a little too deep, others are barely deep enough. A drop of superglue (cyanoacrylate) should secure the dowels nicely. Expect a bit of sanding for a good fit.
.
Created in TinkerCad.

Kitchen Knife Holder