Summary

Another power supply cover. Designed with access hole to the voltage adjustment pot and LED using standard switch/connector cannibalized from an ATX power supply. This was for an upgrade to a 24 volt power supply.

Instructions

1) Print(note there is a decent length bridge of around 2 cm, so if you have problems with bridges make sure to use support)
2) Place cover on power supply, determine where screws should be run through on the sides
3) Drill holes in cover for retaining screws
4) Solder wires to the power outlet(unless you left them on and cut the wires from the ATX power supply pcb)
5) Bend the power outlet wire tabs over so they lay flat against the outlet
6) Pop the switch and outlet into the case
7) Solder the outlet wires to the switch
8) Run the wires in from the printer through the hole next to the outlet
9) Connect all the wires
10) Push cover into place
11) Screw cover to power supply

Printed with SeeMeCNC ABS 1.75 grey filament at 227c nozzle, 115c bed and 40% infill.

Power suppy cover