Summary

Drop tank for the FMS P51D Mustang 1700mm span
Print Settings

Rafts:
No
                                            <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.4</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>0%</p></div></p>                                                    <strong>Filament:</strong> Any PLA+                Any                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Drop tank for the FMS P51D Mustang 1700mm span.  </p><p>Print the front and rear sections in THINWALL (one wall only), no infill otherwise they will be too heavy.  If using Cura, set Surface Mode to NORMAL to provide a joining surface.  Join with CA or epoxy,</p><p>Print 2x mounting pin at 6x walls, 100% infill then glue the mounting pins to the wall of the rear drop-tank section.  Use the drop tank's wing mount as a guide to position the mounting pins.</p></div>
FMS P51D 1700mm drop tank
