BoboVR XL Long Koss Headphone Adapters Adjusted

I started with the original plates but they weren't long enough to comfortably sit on my ears. I switched to this longer plate (thanks ZincLeadAlloy!) which allowed me to get a better headphone positioning, but I couldn't get my Koss ksc75's to stay in the clip where it attaches to the plate even with careful use of a heat gun. Once the clip portion was melted enough to get it onto the ksc75's little clip area I could never squeeze them tight enough. They rattled around and slipped off easily.

I'm a noob at 3D printing, but I managed to move just the clip portion of the original base plate and replaced the chunkier design used in this remix while keeping the length. I used the heat gun to slightly soften the clip before inserting the headphone so it wouldn't break and squeezed them together after inserting. Seems to work fine without any rattle.

Hope it helps someone else!