Summary

I printed a bunch of counters for my daughter, and decided to make something for her to store them in.

I designed this in Fusion360, and printed it on a dual-extruder Ultimaker S5. I've provided two versions of the lid, one with an embedded 'M' logo, and the other blank.

It was printed in PLA with a 0.4mm nozzle.

These are the counters I printed: https://www.thingiverse.com/thing:3316427

Print Settings

Printer Brand:

UltiMaker

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p><a rel="nofollow" href="https://ultimaker.com/3d-printers/s-series/ultimaker-s5/" target="_blank">Ultimaker S5</a></p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.1</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20%</p></div></p>                                                    <strong>Filament:</strong> eSun PLA                Orange                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Wall Thickness: 1.6mm<br>Top/ Bottom Thickness: 1.6mm<br>Wall Ordering: Inside to Outside</p><p>There's a little clearance between the holder and the body, but I found the holder will only fully engage in two of the six orientations - I presume the scaling is a little off in one axis.<br>I applied a small negative offset to the screw threads on the lid (-0.1mm to each face), but it might benefit from just a little more.<br>Flip the lid to print with the top down.  All other parts should print as-is without supports.</p></div>

Magic The Gathering Counter Holder