Clampable Leather Stitching Pony

If you need a stitching pony for leatherwork but already have a bench vice, this is a simpler alternative that takes advantage of your vice!

Just place your workpiece inside the plastic clamp, then place the clamp inside your bench vice and gently tighten.

Hardware Required

• 4” 3/8” Carriage Bolt - Make sure the head diameter is not larger than 22mm
• Matching nylon nut
• Thin leather padding for jaws (Optional)
• 12x2mm round magnets (Optional)

Assembly

1. Slide the two printed pieces together
2. Insert the bolt from the side with the square hold
3. Tighten the nylon nut on just enough to provide a small amount of friction in the hinge
4. Glue leather to the jaws for a softer surface
5. Glue magnets into the holes on the side to hold your needles

Source Files

Designed in https://solvespace.com/index.pl