Summary

Build 3d-printable conic cross-sections using OpenScad. Added a tray where the sections can be displayed together.

Print Settings

Printer Brand:

Lotmaxx

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Lotmaxx Shark</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2 mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>0%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Use 4 perimeters and 4 bottom layers.<br>Use supports only when printing all the pieces at once (conics_all.stl). Set the Support Overhang Angle to 45.</p></div>

Post-Printing

You will need to glue some tabs to keep conics_top in place on top of ellipse, and prevent it from sliding off. You can use magnets too.

Conic Sections using OpenScad