Summary

Conduit rail for XLPower Nimbus to cleanly feed wires through to the back of the model. Note this has only been tested on the mini servo variant and will only work on the left site of the aircraft.

Print Settings

Printer Brand:

Creality

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Ender-3 V3 SE</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.16mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>100</p></div></p>                                                    <strong>Filament:</strong> Any PLA                Any

Post-Printing

The "Front-Clip" has two de-dents that fit into the two vertical holes meant for a zip tie near the front canopy mount. The "Rear-Clip" fits on the open front section below the servos.

I recommend straightening the wires then wrapping them with a bit of tape along the way to keep them organized before laying them into the rail.

It is a snug fit so after inserting the wires and putting on the cover, I fit the clips onto the model then starting at the back where the angled part goes into the tail, move forward with the clip by the servos then finish pushing the rail into the front clip.

*It may be helpful to leave a bit of wire slack near the front (ESC), which can be snugged up by pulling the wires from the rear after the tube is in place.

XLPower Nimbus Conduit Rail