RC Crane V2

Enli10Me2 was a great start, but there were a few small things in my mind that would make it easier to build. I saw that his was based upon another build, so i took the good from that and combined.

First thing i did was enlarge the holes for the screws on the top parts where used. I found the 3m bolts i was using the heads kept stripping off, by doing this i was only putting pressure on where i needed the threads. I used the pulley, hook from ke5etc, also the pads and then modified the base beams to take a bigger screw.

Next I modified the Servo pully to fit on the servo gear, and the platform pully to accept a bearing on the top so it was free spinning.

I fixed the pins on the carriage as they were to big for the bearings.

I took the cab from the crane accessories and cut a slot in the side to run the RC cables.

Still have a few more things to do for cable management, and will post when i get them done.

This is still very much a work in progress, I will clean up the STL's and have some detailed pictures on the build and electronics when i get crane 2 completed