Summary

This is a replacement case for the Choosatron Deluxe Adventure Matrix.

This has not been test printed as yet. If you print this and it works fine, please comment.

The picture is of the original Choosatron case, not my replacement.

Instructions

Print all parts using a high infill setting for strength.
Parts may be a tight fit and require sanding to fit together smoothly.

The original Choosatron case has clips that snap off easily. Those have been removed and screw holes put in their place.

Eight small screws should hold it together well.

Note, I haven't test printed this as yet, however it has been meticulously lined up in Tinkercad to ensure all parts fit. Most parts should replace any existing ones you have.

I'll keep this noted as a Work-in-progress until it is test printed and all parts fit together.

Replacement button pads can be purchased on ebay or DX.

Ebay: http://bit.ly/1zJ5xj4 (one unit)
Ebay: http://bit.ly/1CZuxlJ (Five units)
DX: http://bit.ly/1wOSQvr (Five units)

Reference only, I haven't purchased from any of the ebay links.

Choosatron Replacement Case