Summary

Icosahedron (D20) box with lid. Put your dice in it. Lots of dice.

Print the box upside down.

Feel free to rework it, add hinge, whatever.

Print Settings

Printer Brand:

Anycubic

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Kobra Go</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.32 Layer height x 0.4 width</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>None</p></div></p>                                                    <strong>Filament:</strong> Comgrow PLA                Black                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Printed in PLA at full scale, ~165mm wide, walls were a little thin, but with the right settings, should be sufficient. Print the box inverted. I used a brim to help with plate adhesion. Could use some support, as I had a lot of "fraying" inside when printing, as the inward-sloping inside wall lacked support to print on. I was also printing too fast, as it was reduced when I printed the lid at slower speed.</p></div>

D20 dice box (Icosahedron)