**UPDATED** Tapo C200/210/220 Security Camera Stand

UPDATED:

V2:
Realised my first design was stupid (I had just started 3D Modelling at the time) so I've made a shortened version which takes 3h instead of 22h now, and has the exact same effect, it peaks just over the window sill and I've taken a lot of the chunk out of it, saving a boat load of time and filament.

Despite the height different eh viewing angle and height is nearly exactly the same, however if you would like it easier this new design allows for the file to be downloaded and just click on the bottom surface of the legs and extrude them to the desired length.

New size is 100x100x70mm

V1:
Booster Holder for Tapo C100/C110/C200 (Any with the same dimension rounded bottom)
Bowl in the bottom for holding small objects and hole out back to direct the cable out of.

(I made it the max height an Ender 3 KE can go but the supports always fail midway up the legs, perhaps a raft would help... I've never used one before)

In the case it does fail and you don't want to reprint the legs, just move the entire model down in the slicer and only print the top piece as a separate piece and glue it on top.