Nissan Juke Pin reusable

Please apply HIHGER STRENGTH while printing, I used and suggest 30% filling for strength. 0.2mm layer height.

I tried the original one that worked but difficult to remove, to remove the pin killed both clip and pin (as my case personal experience). I made my own design to be able to reuse both of them. I hope it works for everyone (i did try myself at least).

(updated) I finally recreated a new clipper, with only 3 divided and enforced thickness of divided wall. it's a little bit hard to push through the hole on shelf, but once it's on, it goes not anywhere, My pin is good and stick on it, And the pin is still removable and reusable.

I would like to make the whole set but iI am not well trained with my FreeCAD.I hope it helps people who have lost or broken part as I did.