Ram Cooler V2

This is a ram cooler that I came up with after being unhappy with my previous one. This one uses m3 screws that are approximately 12 or 15mm long, and the rest press fits together. It mounts at the top right of a standard ATX motherboard, then the middle connector is pressed onto the base mount and fan mount to position them. The posts and the connecter may need sanded a little bit to make sure its a snug but not impossible to remove. This was made for a x570 taichi but could likely be used on other boards. You may need too modify the base to make room for fan headers ect. Uses 2x40mm fans and m3 screws for those as well.