LETHAL COMPANY SHOTGUN PROP

Lethal Company Shotgun

I created a prop resembling the double-barrel shotgun featured in the latest version 47 update for Lethal Company. The prop includes a functional break action with ejecting shells. It's important to note that this is a non-functional dummy prop, and it does not discharge any projectiles. Also there are 2 version one has a shorter barrel.

Hardware Components Requirements:
You will require some hardware components, including a pencil, ink spring, and 2 M4 bolts (minimum length of 15 mm), along with 2 nuts for M4.

Dimensions
wide: 9 cm (3.5 Inches)
height: 16 cm (6.3 Inches)
Length: 46 cm (18.1 Inches)
Barrel short: 30 cm (11.8 Inches)
Barrel long: 45 cm (17.7 Inches)

FILES:
for the "long" version the file must end with the word LONG, if it doesn't end with that word then is the "short" version.
the thumbnail picture is the short version

here are the following steps to assemble. I hope this helps
Barrel section:
you will need:
double barrel back
double barrel front
iron sight back
iron sight front
forearm back
forearm front
Hex forearm
I upload a image of how it should fit in this link
https://ibb.co/2yn8QWW
https://ibb.co/55mCJ4L
https://ibb.co/QvJKX8K
https://ibb.co/rs3gHJg
now for the trigger section: you will need an spring (the pencil ink ones)
first you will need to put the spring the circle hole of the "trigger mechanism"
https://ibb.co/4N8yvwB (location of the circle)
it should look like this pic.
https://ibb.co/DMswVsB
then you will need to lock in the trigger mechanism with the "PIN" try to glue a little bit that (make sure that the trigger moves after you lock in the pin) and finally for esthetic you glue the "CapHex"
like this https://ibb.co/yQpTkGJ
and finally you put together both pieces, the barrel and the grip mechanism. with nut and hex. here are the following images for better understanding. you should not tight too much the bolt or it won't rotate.
https://ibb.co/album/5hdbxC