WYZE Pan Cam V3 outside hood

Outdoor mount and rain cover for the WYZE pan cam V3. It is considered an outdoor camera, but this will keep the rain and sun off. Two versions One that uses just a tiny bit less filament and an update that just looks a little less like Lincoln's top hat and more like the Blue Bonnet. It works using the mount that comes with the camera. Just side it up in the slot and put the same two screws right through this and the factory mount. Fasten the camera to it's factory mount first, slide it in and then screw this to the wall. This does need supports to print. Suggest only supporting the main "hole" underneath but avoid printing supports up into the channel that the factory mount slides into. It is a very narrow slot that will be very difficult to remove supports from and should bridge just fine with any printer.