Legion Go - attachment hump to increase SSD cooling

Hi, it's using an idea from my other design: https://www.thingiverse.com/thing:6698885
to increase SSD cooling.

It's not as good as above fully-printed back "Quasimodo" but it's easy to print and attach.
I drilled holes around SSD area as on the photo so it's sucking some air from there and it ends up beging pulled by the fan in the end.

There are 6 versions.
v1-v3 is installed starting from the left side.
v4-v6 instaleld in the middle of the Go

Attached test results with original PSU + USB4 eGPU, prime95+crystaldiskmark, full fan, 30W, W11 balanced, each test was 15min.

v6 gives best SSD cooling
v5 is kinda in-between so I'll be using it for now

After printing just align with holes and attach using a thin double-sided tape.
It's cool enough for me to use PLA+ without deforming but your milage may vary