Modular socket and bit storage

I wanted some modular storage to hold large sockets and hex bits in an area of my small tool-chest so came up with this system, based on a 45x45mm grid pattern.

General Notes
To help prevent the pieces lifting when removing the bits, There are small features on the bottom of the parts to insert neodymium magnets if you wish. I found that once assembled in my pattern, this was not required and the bits should slip on and off the holders with little little/ no resistance.

Printing
Printed with supports, but would probably work without, not a lot of time saved so I went with.

Assembly

1. Pop off the supports if you printed these, push a connector into one piece and then press the second into place.
2. I used a label maker to print the sizes -- depending on your machine, I found printing two lines of text in normal size and then cutting the label in half was an effective way of churning out the labels for the socket holders. For the hex bits, I printed in small font and spaced the labels along a single strip.

Part List