Summary

Its a dock for your iphone 6 plus for your Q card case. It prints in two pieces. One for the dock and the other for the cord integration. It fits even with credit cards stuffed in the back pocket. It works surprisingly well. The fit and docking action is smooth without any binding or connector bending.

Instructions

0.2 mm layer
no rafts
no supports
tested with PLA only
Use iPhone6QcaseStand_meshmixer.STL for integrated supports built with meshmixer. Default supports may mess up the tight tolerance when removing the supports.
PowerCordHolder may not fit your thunderbolt cord. I'm not sure if I used the official cord or a cheap knockoff. YMMV. However, you can always edit the solidworks file to fit your cord!

note: Both files seems to be oriented wrong. I have no clue how to make it right so u'll have to orient it the correct way before printing.

Print both files.
Install the thunderbolt cord on the cord holder
Prefit the cord holder to the case stand
Superglue or hotglue (I did this option) cord onto the cord holder
Put both parts together
Install on desk with double sided tape
Profit!

iPhone 6 Plus Dock for Q Card Case by CM4