Summary

Parts for an Enclosure for Lulzbot Taz

Instructions

These are parts I created in tinkercad to build a plexiglas enclosure for lulzbot taz. Enclosure was built with 1/4" plexiglas and 10-24 x 3/4 screws and nuts (151 screws and bolts, probably a little overkill!)

The enclosure is 34" x 27" x 24". I currently have the printer the same with all electronics inside the enclosure which I was told would be okay. The only thing I may change is where the spool is located as it is a little challenging to change the roll on that side of the enclosure.

The gears I used for the door handle are from this file http://www.thingiverse.com/thing:64837.

Lulzbot Taz Enclosure