Piclop camera and laser mounts

These parts replace the camera holder and laser mounts for the Ciclop 3D scanner in order to make it compatible with FreeLSS, which uses a Raspberry Pi rather than an Arduino and has different geometry requirements for the camera and lasers. They are designed to be combined with the Ciclop turntable in order to make a complete scanner. A series of blog posts describing the project begins here.

Please note that this is very much a work in progress and the design, especially the camera holder, will likely be revised. I'm releasing the design now because a few people have asked for the parts, but if you print them now be aware that they may not be fully functional.