Tweaked Betrayal at House on the Hill Dice Tower

Original design by Taython! All credit to them for this great idea and model!
(Follow the link to the original model for more instructions, comments, and makes of this design)

Main Changes:

• Tweaked "Floor 1" so that the dice catch can slide in further. Also thickened a couple of small segments that were too thin to print with 0.4mm
• Remodeled the tea light holder to be smoother, and easier to insert/remove.
• Added a "retention cover" that can be glued in place above the tea light holder, to prevent the holder from falling into the house.
• Added optional bottom covers/plates, that can be used to close off the bottom, and give a slightly nicer/more finished look.

Additional changes:

• Manually repaired Awning mesh
• Fixed floor 2 mesh using netfab

I really like this design and wanted to print one for myself. However, there were a couple of things I wanted to add/tweak for my use, and I thought it would be good to share in case someone else gets use out of it.

I've also re-uploaded the original models alongside these modified models, just for convenience. Again, all credit to Taython for their creation!