[PythonSCAD] Broomstick thread to gopro 3 prong

Update 20250620:

• Changed print orientation to be "splitted". Need to join with a ziptie.

Update 20241223:

• Added collar for extra strength. Rough use broke the print right at the corner where the prongs and the base is attached.

Original:
Remake of https://www.thingiverse.com/thing:6545325. In PythonSCAD for easier maintenance.

Adjusted the gopro mount dimensions, since the mooncactus original values were too tight.

You can just print threaded_female_end_gopro_three_prong.stl. The pythonscad file is a bit wonky that, it seem to have CSG issues dealing with open mesh. I worked around it by exporting intermediate components as STL and reimport back.

Printing hex-side on baseplate is fine. I used 0.02mm resolution with 15% infill on adaptive cubic (See screenshot).