Summary

The Name says it all.

Instructions

This spool holder is made from 3 feet of ¾" PVC. 3 elbows, 1 tee, 3 end caps
Material list:
3' ¾" PVC
3 ¾" End Caps
3 ¾" Elbows
1 ¾" Tee
Cut list:
4 - 6" pieces (2 long legs, 1 vertical, 1 horizontal piece for spool ).
2 - 3" pieces (Short pieces are for either side of Tee).
Assemble as picture shows. I did not even glue the fittings. I used a plastic no bounce hammer and tapped the pieces together. I did this so I could adjust the legs to lay flat on table. The tee is not glued either, because I wanted to make sure it was 900 to the table. The friction fit holds everything snugly together.
I did not put the 3rd end cap on. I still have not made the spool holder bushings.

3/4" PVC Spool Holder