The Batman Helmet/Cowl/Mask- Separated by Printable Parts with Magnet Slots

Credit to Budwin for making this amazing mask and dcobert for splitting it into printable parts along the seam that already existed on the mask. They both did a fantastic job with this model and deserve all the credit. I just added magnet slots on it. I probably did not add them in the best way possible and they are not perfect by any means. A couple of them are slightly offset but they mostly match up. I am not very good at this and it is the best that I could do. The magnet slots should fit 6x2 mm magnets. I had 5x2 mm magnets that I wanted to make sure would fit after sizing. With the way I added the magnet slots, smaller magnets made more sense anyways. Otherwise the model would have to be much bigger to fit. I also added an option with the ears already attached. And again credit to dcobert for splitting the model and Budwin for making the model. Budwin does great work and makes some awesome masks and props. I added a link to his profile below.

https://www.thingiverse.com/budwin/designs

If you have any questions or suggestions just comment on this post. Also let me know how your prints turned out.