Necklace Stand with spider web at top

This a necklace stand I designed to hold 16 necklaces. I wanted to make it a little more interesting to look at, so I added the spider web design at the top. I used a 11.5" long 3/8" oak dowel for the support, but you can print a plastic dowel if you prefer from the included file. The widest part is slightly less than 200mm. I also included a test part so you can check whether the hole prints the correct size on your printer. I still had to sand the dowel a little so it had a nice slip fit & would turn easily.

There is an updated version of this design located here: http://www.thingiverse.com/thing:1054244