Hubsan X4 Clone

Micro quadcopter designed to be used with Hubsan FC (or other - e.g. AlienWii) and 8 mm motors.

Motor holes are currently 8.5mm to allow for clearance
FC mounting holes are 2.5mm diameter, 20mm square (For AlienWii).

02/21/15 UPDATE: Latest build does not fly well. I found that the motors do not sit level or perfectly vertical; Consequently it is very twitchy and drifts and wobbles a lot when there is not control input. Yes I did recalibrate the FC. I believe that this has something to do with the consistency of the 3D printing. The arms are quite flexible and are also slightly warped and twisted despite the heated bed that I printed one. I'll post another update if I figure out a solution.

This is obviously a work in progress and will change without notice.