MiniNES

MiniNES updated for the Raspberry Pi v2 / B model. Let me know what you think! This was a great learning experience.

Known Issues:

• Posts should be larger for stability. (Used #2 @ 1/4")
• Needs hole for Micro-USB. (Dremeled hole to fit)
• Hole in back for power cable isn't used.
• Lid needs to be slightly wider to fit properly.

Ideas for next v2:

• Get Pi into a better position to cut down on cable clutter. There is a lot of extra room inside the case that can be put to use.
• Put a USB extension to the front of the case where controller would be on original NES.
• Fiber optic routed to where Power Led would be on original NES.
• Get buttons to be functional.
• Get a better 3d printer. The one I used annoyingly warps things.

Tips for others:

• Download RetroPie for Raspberry Pi - http://goo.gl/kxyQmO
• Copy image to MicroSD card - http://goo.gl/1vAUij
• Follow these installation instructions - http://goo.gl/oEE4O1
• How to setup XBOX 360 controllers - http://goo.gl/3bPC52