Summary

When I bought a second hand Top Shot Elite gun, it didn't come with a stock. So I made one.

Instructions

Note that both pieces are quite long - verify that they'll fit on your printer. Both (just) fit and worked on an Ultimaker.

Print both (a) and (b) parts - (b) should slide smoothly onto (a). If there isn't enough friction, drill a hole ~2 cm along (b) on the left hand side (i.e. the side with the serrations on (a)) and insert a screw or similar. When printing (a), you need to print with a high fill ratio (I used 100%) as otherwise it will likely fail where the narrow and wider parts meet.

Top Shot Elite replacement Stock