Adult size pacifier parts.

These are customizable and designed to use with pacifier addict teats.

The mouth shield is best printed standing vertically then tipped forward 15 degrees and with support enabled.
It's best to sand down the inside of the mouth shield, I started at 60 grit then moved on to 150, then 220, then 400. In between sanding I hit it with a heat gun, getting it just hot enough to be pliable (be careful if you do this because they will shrink or deform if you apply too much heat) it's not a necessary step but it helps to smooth out the grooves by melting the plastic dust from sanding into the grooves. After sanding I apply a food grade clear coat in 3 very light coats, waiting 10 minutes between coatings and allow a full week to cure before using.
I recommend the ring be printed with support.
The button can be printed flat without support and should not require any work once they finish printing.