10th Doctor Hand in a Jar

I needed this prop from Doctor Who for a cosplay, but could not find it anywhere so I made my own by looking at dozens of reference photos and with lots of guesstimating. This is my first entirely from scratch project (except for the hand itself) so I'm open to feedback. Obviously, I couldn't fit this all on my ender 3 v2 so I split it into parts and then needed to split them again in cura, I included an stl of the whole thing for reference and in case anyone would like to split it themself differently than I did. Please note that the hand is centered between the bottom and the light, not between the top and bottom so if you are using a different light or none at all you may want to center it yourself. The model I used is the Bare Right Hand Model by Pandaero scaled to 120% but I also credited the original creator of the hand. I did a color change between the hand stand and the hand itself.

For the glass of the jar I used this acrylic tube [145mm(5.7") ID 150mm(6") OD 10"] and there is a notch in the top and bottom that fits it perfectly. https://www.amazon.com/dp/B0B9C1MSZ2?ref=ppx_yo2ov_dt_b_fed_asin_title

For the light I used this RGB puck light with remote which came with an adhesive to stick on the underside of the top and I used some black electrical tape to make it less noticeable. https://www.amazon.com/dp/B078GG4Z1D?ref=ppx_yo2ov_dt_b_fed_asin_title