End Cap for 22mm Pipe Solvent Weld (ABS / Acetone Vapour Bath only)

Print with Good Infill.

Always Acetone Vapour Bath.

REMEMBER: Your Printer Settings & Set Up will have a greater effect on deign usability, with this in mind please test before use, and use only where you can easily access.

I can test and certify any of my designs but if you then print on a repstrap with poor calibration, poor filament, get inclusions and dont AVB, then my testing and certification are pointless.

22mm Solvent Weld T-PIECE (Gen2):
http://www.thingiverse.com/thing:653890

90° Ø22mm Solvent Weld Elbow (Gen2):
http://www.thingiverse.com/thing:656548

90° Ø22mm Solvent Weld Elbow Low Build (Gen2):
http://www.thingiverse.com/thing:650329

90° Ø22mm Solvent Weld Swept Elbow (Gen1):
http://www.thingiverse.com/thing:639743