Proxmark3 Case for chinese clones.

A neat and functional case for Proxmark 3 clones, this case allows you to slide the top off exposing the antennas if you need to get a tag really close. You can attach the PM3 unit to the bottom shell by removing two screws and fastening them through the case, making this an easy case to remove if need be. The button can be attached with glue dots at each end (unless your printer is nice and accurate in which case you may be able to spring it) I used some electrical tape, once the PM3 is in it stays in place well. Lights are visible through the holes, but if you have some clear filament, you can cut little pieces and poke them through to act like fibre optics.

I printed the bottom base down, the top in the same orientation with supports and the button with the flat strip on the print bed.