5x5 disk magnet mount for Asquel's logitech c270 case

Didn't had 10x5 magnets, so "designed" this for 5mm diameter disk magnets. I used two stacked 5x2 disk magnets

Holes for magnets are exact 5mm, so you probably have to test-print this couple times, playing with "hole expansion" or "horizontal expansion" in your slicer, scince even magnets are not always exact 5mm (mine was 5.2mm).

On attached photos you can see glue-mess, because i didn't bother about the looks and pressure-fitting the magnets, but you can do it!