DW733 DW734 planer vacuum fitting: split for printing on small footprint.

3.9.2026 I just discovered that my planer is actually a DW734. So apparently this design actually fits both 733 and 734.

I adapted from LFminTX's helpful design for my new/used DW733 planer. I have an AnyCubic Kobra Go with a fairly small bed which could not accommodate the original model. I split the original design in half and added a flange to provide more surface area for glue-up.
This was sliced in Cura and printed in two section on my Kobra Go using full supports and 0.6 nozzle and standard PLA. I recommend using the position optimization feature to print at an angle and reduce the amount of supports required. The final print def needed a bit of clean up on the edges but it fits snugly onto the planer. Used epoxy to glue up the two sections. It's a bit fragile due to the size and the PLA but saved me 85 dollars on the OEM model.