Ego Wet/Dry Vacuum (Rubber Bar) Attachment Mount

The Ego Wet/Dry vac is awesome, but there's one attachment that it comes with that it doesn't have a spot for. This attachment resolves that.

• Print at 75mm End-To-End
• Best orientation to print it at is on it's side, more walls = stronger == less flexy
• Meant for use with 60LB Gorilla TAPE
• Can be mounted to the Front, or either Side of the Wet/Dry Vac
• To insert attachment:
  • Hold on it's side (with the small rubber fin horizontal)
  • Slip down into Attachment Mount
  • Twist 90 degrees
  • Can be slid in from the side as well.