Alternative Powder rose necklace--Arcane

I wanted to make this necklace and happened to have white and grey filament. I didn't want a lot of supports, so I prepared the files to be able to print it in different pieces. You should print one of each (the roses in white, the rest in grey), except for the spacers (print them 2 times). For the pin, I used a piece of wire (1.25mm). I wanted it to spin well, so I cut off a piece of each spacer, so they don't graze the external part. I used a permanent blue marker to paint the image of the rose.
Hope u enjoy it!!

𝗕𝘂𝗶𝗹𝗱𝗶𝗻𝗴 𝗜𝗻𝘀𝘁𝗿𝘂𝗰𝘁𝗶𝗼𝗻𝘀:
First, pass the wire/pin through the external, then spacer, internal, another spacer and finally the external again. Glue the spacers to the internal, but make sure it doesn't stick to the external. Glue the A and B sides to the wire. Finally, glue the botton and top to the wire.