Back to the Future: Scaled down TFC Drive Circuit

I designed this to fit on the center console of my '91 S10, complementing my scaled-down Flux Capacitor and Time Circuits. While it’s not screen-accurate, it’s as close as I could get while still being happy with the result.

I'm still making tweaks, so future updates may improve the design. In a later release, the handle will power the red and green LEDs.

Printed in PETG with four walls and 20% infill. I've also included an acrylic mold to help shape the acrylic properly.

The handle was initially printed in black resin, but the quality wasn’t great. I ended up using my FDM printer, and after some post-processing, it turned out much better.

I also drilled a hole in the rear top of the switch base to route my wires.

BOM
1 mm Acrylic Sheet (Dayton Cover)
https://a.co/d/b3j958l

4 Larger Toggles
https://a.co/d/7y9rYcE

3 Smaller Toggles
https://a.co/d/eqTEeWT

3/4 in Rod (inside of Dayton Switch)
https://a.co/d/1X12ens

.5 mm Brass (for inside the Dayton Switch)
https://a.co/d/b4Kuoi3

Red Push Button
https://a.co/d/cJ1kd8N

Green/Red Leds
https://a.co/d/2GcyWzk

1 or 2 mm screws (optional to mount the front and rear pcs to the switch base, and acrylic to the rear)
3 mm screws various sizes
3 mm washers
3 mm nuts
1 spring from inside of pen
Wire (black, I used red)
Ring Terminals (blue and red)

I used a Rotex Label Maker found on Ebay
I used red and black labels for the Rotex