Bunch of Quality of life mods for Wasp 77

++Update 20/04/2025

• Front barrel holder is split into top and bottom so that you can print them vertically to strengthen the fingers
• Added expanded grip with expanded battery cover. Note that the battery cover is held in by M3 screws
• Added dart date and ramrod that are smaller than current dart gate and ram rod. This is to reduce the problem when you darts get squished an the pusher pushes 2 darts at the same time. A smaller ram rod reduces the problem. FPS may slightly suffer. YOU WILL NEED A 13mm OD, 1.5MM CROSS SECTION O RING.

Side shims are just to let the screws press down on the metal bars on the side so that they do not wobble.
Spring spacers are to precompress your spring or if your spring is too short.
Extended stock is a replacement stock that is longer
Extended battery cover requires you to use 2x M2.5 x 18mm screws.

For those who wants to use 3rd party 16mm outer diameter barrels
Dart gate spring holder is to hold your spring in place when swapping barrels. You glue it to the front of the dart gate with the indent facing towards the return spring to hold the spring in place. Note that the diameter is a very tight fit with a 16mm barrel. This is to reduce air loss between the dart gate and the barrel

Front barrel holder and nut replaces the front metal plate. Note that the barrel may require 1 layer of duct tape so that the holder can grip the barrel. NOTE: THE BARREL HOLDER HAS A TENDENCY TO BREAK AT THE FINGERS DUE TO LAYER LINES. BE CAREFUL.