Dual 18650 box mod with Tomorrowland logo

First working version of my box mod. I used around the house parts to test fit and get working. Don't mind the burnt wire or the wonderful soldering, this is a low quality print so I did low quality work. If you build this and assemble it make sure to use a mosfet or keep your builds high. I have a 5amp switch so I won't build any lower than 1 ohm. Happy vaping.

Parts list

-battery contacts from a xbox controller and from several old tv remotes

• 12ga wire (way to big but all I had)
• Top cap off my copper mech mod
• 5a switch from an intercooler sprayer iv'e had since 2006
• solder that's made for copper pipes

Lid is press fit and works well, but it will most likely wear out over time.

Printed on robo 3d with PLA

Low settings
.03mm layer
20% infill
210 degree extruder
50 degree bed