Arrma Vorteks 223 Mudguards

A set of mudguards for the Arrma Vorteks 223 RC car, though will likely fit other variants of Vorteks and possibly other Arrma 1/10th scale cars. This help protect the rear suspension and driveshafts from sand, dirt and grit thrown up by the front wheels.

They are attached to the rear lower wishbone via 2 x M3x8mm button head screws per side.

The hole in the end by the wheel is to allow you to push out the rod without removing the mudguard from the wishbone, and uses a M3x3mm (same size as what stops the rod coming out the back) button head screw to stop dirt and grit getting in there.

Print settings and material are as you think appropriate. These were printed in PLA at 0.2mm, 20% infill. On the larger models like the Kraton 6S, I tend to use TPU for mudguards, but not yet tried TPU on the Vorteks.