Summary

What could possibly make the hot-pipe shroud for the Expobar / Brewster coffee machine better?

Bunnies!

Instructions

You'll need to print this with supports.

I use Simplify3D - a marvelous slicer; fast and flexible. i did try printing with HIPS dissolvable support, but the blobs left on the model with filament changeover caused the print to fail. So I ended up printing with "native" supports, which worked just fine.

Simplify3D allowed me to print the base layers at low resolution, stepping down to 100micron as more detail / better finish was required. it also allows you to specify custom support densities that increase as the support gets closer to the supported material. Very nice! worth a look if you have not done so already.

Bunnified Expobar / Brewster hot pipe shrouds