Insta360 Mounting Clip. 1/4 bolt

I edited someones gopro clip a while back to mount my insta360 on a helmet.
Unfortunately I cant find the original clip i used to do this edit.

Use a standard 1/4 x 25mm bolt with 2 washers and a lock nut.
You'll need 1 normal socket and 1 deep socket to tighten it.
When my insta360 x3 is snug on the bolt, there is just under a 2mm gap between the bottom of the camera and the printed clip.
This next step isn't necessary but I did it anyways.
I tightened the bolt so the camera faces forward when snug, and used superglue and baking soda to strengthen and cement it in place.

Best of luck 👍
I'd like to see your copies please 😊