mini Satsana Remix - Ender 3 V2 w/ Original BL/CR Touch Mount Spider hot end 3.0, Unitak Direct Drive

Mini Satsana remixed for use on Ender3 v2 with direct drive mod (Unitak) and Spider v3 hot end (note this would work perfectly fine with original hot end too since they are the same size)
mine is running klipper and can print with much better quality now since the cooling is finally on both sides, for higher speeds >250mm/s I'd advise going for a bigger fans if you don't do big prints either add an adapter or print another remix with 2 4010 fans otherwise this should work pretty good <200mm/s with 5-10K acceleration

This remix is made to fix issues with the body hitting the wheel nuts but also straightened the cooling since mine was at an angle once installed on Unitak direct drive plate somehow. Fan duct have been shaved to avoid touching the bed before the nozzle does.

screws used were basically factory but I may have used shorter/longer ones where it fits I'd advise to have a few M3 of different size at hand just in case but you should be good with factory screws

This mod uses the original BL-Touch mount (should be the same for CR-Touch and work straight out of the box but haven't got one available to check)
So you won't need to adjust your probe offsets

Print at the layer height you want mine was done out of PLA and works perfectly fine printing PLA/PETG (would recommend PETG/ABS if you need higher temperature filaments)
warning : print it with support from bed ONLY!!! or the fan duct will be filled with supports blocking your airflow...!!!