Magnetic Watch Band/Strap Box

This storage compartment will hold six of any generic watch straps (for example 20mm and 22mm straps). It's made to be portable and dust-protected, hence the lid. The individual compartments may be quite big, but I wanted to make them as universal as possible. Note that Apple Watch and Galaxy Watch Ultra straps are not supported in this version due to their width. It'd be pretty easy to make a bigger version for them, let me know if you'd want one.

the dimensions are as follows:

box with lid: 172mm x 88mm x 36mm
box without lid: 172mm x 88mm x 32mm
inner spaces (x6): 160mm x 12mm x 28mm

Instructions:

You need 8 magnets with the dimensions of 6x3mm.
For the box, pause the printer at layer 148. For the lid, you will need to set the pause at layer 27.
Once the printer stops, place the magnets in the holes. Make sure they have the correct orientation. It might be tight, but they fit. Do not remove the printplate from the heatbed!
Once you're done, let the printer continue printing.

How do I set a pause at a specific layer?

In Bambu Studio, PrusaSlicer or OrcaSlicer, go to Preview in the upper menu. Slide the slieder at the right side to the desired layer height. In our case, it is the first layer, which will cover the magnet holes. Right-click and choose “Add Pause”. That's it! The printer will now pause at the start of that layer until you unpause it. Depending on your printer model, it will send a notification when it paused.